ASTM A992 W10x100 W10x112 Wf Steel Beam

W10x100 w wide flange beam: section height is about 282 mm, flange width is about 263 mm, web thickness is 17.3 mm, flange thickness is 28.4 mm.

W10x112 w shape structural steel: section height is about 289 mm, flange width is about 265 mm, web thickness is 19.2 mm, flange thickness is 31.8 mm.

W10x100 w shape beam: tensile strength is not less than 560MPa, yield strength is not less than 460MPa, elongation is not less than 10%, section shrinkage is not less than 45%, impact energy is not less than 39J, impact toughness value is not less than 49J/cm², NMness is not more than 229HB.

W10x112 w flange beam: It is made of A992 material as W10x100 h beam wide flange, and its mechanical properties are roughly similar. However, due to the different cross-sectional dimensions, the load-bearing capacity and deformation characteristics under actual stress will be different.

A992 h section beam is a common American standard H-shaped steel material with good strength, toughness and weldability. It can maintain stable mechanical properties under different environmental conditions, is suitable for a variety of structural applications, can withstand large loads and stresses, and has good seismic resistance and fatigue resistance.

A992 h shaped steel is usually produced by hot rolling.

First, the steel billet obtained by steelmaking is heated to a suitable temperature, and then the steel billet is gradually rolled into the required H-shaped steel shape through multiple rolling processes.

During the rolling process, the dimensional accuracy, surface quality and mechanical properties of the steel are guaranteed by controlling the process parameters such as rolling temperature, speed and reduction.

After rolling is completed, subsequent processing steps such as cooling, straightening, and flaw detection will be carried out to ensure that the products meet relevant standards and quality requirements.