ASTM A572 and Its Strength Classes
ASTM A572 is the standard specification for high-strength low-alloy columbium-vanadium structural steel, used for riveted, bolted, and welded construction. The specification defines several strength levels, of which Grade 42 with a minimum yield of 290 MPa, Grade 50 with a minimum yield of 345 MPa, and Grade 60 with a minimum yield of 415 MPa are the most common. Grade 50 is by far the most widely ordered for H-shape beams because it offers a 38 percent higher yield than A36 at a modest cost increase, which translates directly into lighter members and lower fabrication and transport cost.
Why Use A572 for Building Construction
Using a 345 MPa yield grade allows the designer to reduce section sizes for the same load, which is especially valuable for long-span beams, heavily loaded columns, and transfer members. The weight saving also reduces foundation loads, and the smaller sections simplify connections and erection. Because A572 Grade 50 is weldable with standard low-hydrogen consumables and is available in all common H-shape sections, it is the default high-strength grade in American building practice.
H-Shape Section Availability
A572 beams are rolled as W-shapes to ASTM A6, including the W8, W10, W12, W14, W16, W18, W21, W24, W27, W30, W33, W36, and W40 series, and as M and S shapes on request. Depths range from about 200 mm to 1000 mm, with weights from about 15 to 400 kg per meter. The same strength level is also available in HEA, HEB, and IPE series for projects designed to European section practice, and in built-up welded girders where non-standard sizes are required.
Fabrication and Connection Considerations
A572 Grade 50 requires low-hydrogen welding consumables such as E7018 electrodes, and thick sections may need preheat to control the heat-affected-zone hardness. Holes for high-strength bolting are punched or drilled to the shop drawing, and the higher yield strength does not change the standard connection details. Because the grade is stronger, weld sizes are often governed by the thinner member or by fatigue requirements rather than by static strength, and the fabricator should confirm the weld design with the engineer for heavily loaded joints.
Design Benefits and Typical Applications
A572 H-beams appear in industrial buildings, warehouses, mezzanines, equipment platforms, crane support structures, and multi-storey frames. The grade is also common in bridges and heavy machinery supports where members are subjected to repeated load cycles. In all these applications, the higher strength reduces tonnage and cost, provided the design is controlled by strength rather than by stiffness; where deflection controls, a deeper but lighter section may be the better choice.
Frequently Asked Questions
Q: What is the yield strength of A572 Grade 50?
Grade 50 has a minimum yield strength of 345 MPa and a minimum tensile strength of 450 MPa.
Q: Can A572 beams be welded to A36 members?
Yes, mixed joints are welded with consumables matched to the lower-strength base metal, and the connection is designed for the weaker member.
Q: Is A572 more expensive than A36?
It costs more per ton, but the higher strength usually reduces the total tonnage, so the overall structure cost can be lower.
Q: Which H-shape sizes are available in A572?
All standard W-shape series from W8 to W40 are available, along with HEA, HEB, IPE series and built-up welded sections.
Q: Does A572 require special welding?
Low-hydrogen consumables and, for thick sections, controlled preheat are recommended; the welding procedure qualification covers the required tests.



















