Galvanized and Black Carbon Steel Angle Bars in ASTM A36 and Q235: Equal and Unequal L-Sections

Mar 05, 2026

Leave a message

Black and Galvanized Angle Bars

Carbon steel angle bars are supplied in two basic finishes. Black angle is delivered as-rolled with the natural mill scale on the surface, ready for painting, welding or galvanizing at the fabricator. Galvanized angle has been hot-dip coated with zinc, giving immediate corrosion protection for outdoor service without further surface treatment.

Material Grades

ASTM A36: minimum yield strength 250 MPa and tensile strength 400-550 MPa; the standard structural grade in North American projects

Q235 (GB/T 700): minimum yield strength 235 MPa for thickness up to 16 mm and tensile strength 370-500 MPa; the standard Chinese structural grade

Both grades are low-carbon structural steels with good weldability and formability, and they are accepted as equivalents in many international projects.

Equal and Unequal L-Sections

Equal angles have two legs of the same width, for example 50 x 50 x 5 mm, while unequal angles have legs of different widths, for example 75 x 50 x 6 mm. The L-shaped section provides efficient resistance to bending and axial forces, and both forms are available in the full range from 20 x 20 x 3 mm up to 200 x 200 x 24 mm for equal legs.

Finish Selection Guide

Black angle: choose when the structure will be painted, galvanized later, or used in a dry indoor environment

Galvanized angle: choose for outdoor, coastal and humid environments where long maintenance-free life is required

Pre-punched: holes can be punched before galvanizing so the coating protects the hole edges

Typical Applications

Bracing, brackets and connection cleats in steel frames

Transmission towers, lattice masts and support structures

Handrails, stair stringers, cable trays and pipe supports

Agricultural buildings, greenhouses and storage racks

Frequently Asked Questions

Q: What is the difference between black and galvanized angle?
Black angle is supplied with the mill scale as-rolled, while galvanized angle carries a hot-dip zinc coating that provides immediate corrosion protection.

Q: Which grade is stronger, A36 or Q235?
A36 has a minimum yield of 250 MPa compared with 235 MPa for Q235, but the two grades are broadly equivalent for general structural use.

Q: Can black angle be galvanized after fabrication?
Yes, black angle can be fabricated, welded and then hot-dip galvanized to BS EN ISO 1461 so the welds receive the same protection.

Q: What lengths are standard?
Standard lengths are 6 m and 12 m, with cut-to-length pieces supplied for fabrication projects.

Q: How is an angle size written?
An angle is described by leg width, leg width and thickness, for example 50 x 50 x 5 mm for equal legs or 75 x 50 x 6 mm for unequal legs.