H Beams in SS400 and ASTM A36 for Structural Steel Buildings: Grade and Application Guide

Aug 20, 2025

Leave a message

GBT706-2016Hot-Rolled-H-Beam.pdf

H Beams in Structural Building Frames

H beams are the primary members of structural steel buildings, serving as columns, rafters and beams in portal frames and multi-storey construction. Their H-shaped cross-section carries bending and axial loads efficiently, and the parallel flanges simplify bolted and welded connections. For most building projects, the economical grades SS400 and ASTM A36 cover the full range of structural requirements.

SS400 and ASTM A36 Compared

SS400 (JIS G3101): minimum yield strength 245 MPa, tensile strength 400-510 MPa; the standard Japanese structural grade

ASTM A36: minimum yield strength 250 MPa, tensile strength 400-550 MPa; the standard American structural grade

The two grades are closely equivalent in strength and are frequently specified interchangeably in international projects. Both are low-carbon steels with excellent weldability and formability, and both are supplied with mill certificates showing heat number, composition and test results.

Section Sizes for Buildings

Hot-rolled H beams for buildings range from about 100 x 100 x 6 x 8 mm up to 900 x 300 x 16 x 28 mm, with wide-flange column sections included in the same series. Standard lengths are 6 m, 9 m and 12 m, and sections can be cut, drilled, coped and cambered to the fabrication drawings before delivery.

Frame Application Guide

Columns: wide-flange H sections for stability in both directions

Rafters: H beams sized for roof loads and deflection limits

Secondary beams: lighter H sections for floor and roof support

Bracing: H beams or channels for wind and seismic stability

Protection for Building Members

Building H beams are supplied black as-rolled for painting on site, shop-primed, or hot-dip galvanized to BS EN ISO 1461 for outdoor exposure. Fire protection, where required by the building code, is applied by intumescent paint, board encasement or sprayed fireproofing after erection.

Frequently Asked Questions

Q: Which grade is better for a steel building, SS400 or A36?
They are closely equivalent in strength and weldability; the choice normally follows the design code or specification governing the project.

Q: What is the yield strength of SS400?
SS400 has a minimum yield strength of 245 MPa and a tensile strength of 400-510 MPa per JIS G3101.

Q: What sizes are used for building columns?
Column sections commonly range from 200 x 200 mm to 500 x 500 mm in hot-rolled H beams, with welded sections available for heavier loads.

Q: Can H beams be delivered cut and drilled?
Yes, beams can be cut to length, drilled, coped and prepared for connections before delivery to reduce site work.

Q: Are mill certificates provided?
Yes, each bundle is supplied with mill certificates including heat number, chemical composition and mechanical test results.