JIS SS400 Carbon Steel Angles: Galvanized and Pre-Painted Options

Mar 27, 2024

Leave a message

1. The SS400 Base Grade

SS400 is the general structural steel grade of JIS G3101, with a tensile strength of 400 to 510 MPa and no guaranteed yield point. It is the most widely used grade for hot-rolled angles in Japan and the surrounding markets. SS400 angles are dimensioned to JIS G3192, which gives the leg sizes, thicknesses, masses and section properties of equal and unequal leg angles.

2. Bare Angles for General Service

In dry indoor service, SS400 angles are used bare with the mill scale intact, and the slight surface rust that forms in storage is normally harmless. For indoor frames, racks, brackets and machinery supports, the bare angle is the most economical choice. If the appearance matters, the angle is supplied with a light oil film or a primer coat on request.

3. Hot-Dip Galvanized Angles

For outdoor structures and humid environments, the angle is hot-dip galvanized after rolling, which forms a zinc coating over the whole surface, including the inner faces of the legs. The coating weight is typically 45 to 85 microns depending on the specification and is verified by weighing. Galvanized angles are used for transmission towers, outdoor racks, fence posts, solar supports and any structure that must survive weather exposure without frequent repainting.

4. Pre-Painted Angles

Pre-painting applies a factory primer and finish coat to the angle, which gives a controlled appearance and a clean surface for the final paint system on site. Pre-painted angles are used where the structure is visible, such as architectural frames, handrails and exposed steelwork. The paint system is chosen for the environment, and the coated angle is protected during transport with corner protectors.

5. Choosing the Protection

The choice between bare, galvanized and pre-painted depends on the environment, the design life and the maintenance budget. Bare angles are cheapest but need painting or will corrode outdoors; galvanizing gives the longest protection with the least maintenance; pre-painting suits visible structures where the finish is specified by the architect. The coating option should be stated clearly in the order together with the size and grade.

Frequently Asked Questions

Q: What is SS400?
It is the general structural steel grade of JIS G3101 with a tensile strength of 400 to 510 MPa, used for angles, channels and beams.

Q: Which standard gives SS400 angle dimensions?
JIS G3192 gives the dimensions, masses and section properties of JIS angles, while JIS G3101 defines the material grade.

Q: What coating weight is typical for galvanized angles?
Hot-dip zinc coatings of 45 to 85 microns are typical, verified by the stripping method, with heavier coatings for aggressive environments.

Q: Are galvanized angles suitable for coastal service?
Yes, galvanizing is an effective protection for coastal structures, and a duplex paint system can be added for very severe conditions.

Q: What is pre-painting?
It is a factory-applied primer and finish coat that gives a controlled appearance and a clean base for the site paint system.

Q: Can bare angles be used outdoors?
Only temporarily, because the mill scale and bare steel corrode quickly outdoors; for permanent outdoor service, galvanizing or painting is required.