Why A36 U Channels Are a Workhorse Section
A U channel has a web and two flanges on the same side, forming a U-shaped cross-section. It bends efficiently about its major axis and offers a flat web for simple connections, which makes it one of the most economical sections for purlins, light beams, frames and machine bases.
Grade Requirements of ASTM A36
A36/A36M requires a minimum yield strength of 250 MPa (36 ksi) and a tensile range of 400-550 MPa for structural shapes. The low-carbon chemistry keeps the steel easily weldable with standard electrodes and processes, and the grade is accepted by the major design codes without restriction for general structures.
Channel Size Series
Hot-rolled channels are available in metric and imperial series. The metric series follows the web height and flange width, for example 80 x 43 mm, 100 x 48 mm and 200 x 90 mm, while the US series uses the C-shape designation such as C3x4.1, where the first number is the depth in inches and the second the weight in pounds per foot. Both series are supplied in 6 m and 12 m lengths.
Tolerances and Quality
Web height, flange width, thickness, camber and sweep are controlled to ASTM A6/A6M for US sections and to the relevant metric standard for the GB and EN series. Each heat is tested for yield, tensile and elongation, and mill certificates record the results for traceability.
Fabrication and Protection
A36 channels can be cut, drilled, punched, notched and welded without preheat under normal conditions. For outdoor service, hot-dip galvanizing to BS EN ISO 1461 is the standard protection; for indoor use, the black mill finish or a shop primer is sufficient.
Typical Applications
Roof purlins and side rails in portal frames
Light beams and lintels
Machine bases and equipment frames
Vehicle and trailer chassis members
Bracing and edge members in buildings
Frequently Asked Questions
Q: What are the mechanical properties of an A36 channel?
Minimum yield strength is 250 MPa with a tensile range of 400-550 MPa, verified by tensile testing on each heat.
Q: What is the difference between a U channel and a C channel?
The terms describe the same U-shaped geometry. C-shape is the US designation, and U section is the European and metric term.
Q: Can A36 channels be galvanized?
Yes, hot-dip galvanizing to BS EN ISO 1461 is standard practice for outdoor channel members.
Q: What channel sizes are commonly stocked?
Metric sizes from 80 x 43 mm to 200 x 90 mm are the most requested, with US C-shapes from C3 to C15 available for North American projects.
Q: Are mill certificates supplied?
Yes, mill test certificates record the heat number, chemical composition and mechanical test results for the delivered channels.
Q: Can channels be supplied cut and drilled?
Yes, cutting to length, punching, drilling and notching are available to the fabrication drawings before surface treatment.



















