A Grade for Every Load Level
Angle sections are rolled in grades from light Q195 to high-strength Q420 under the GB system, and from SS400 to SS540 under the JIS system. The grade ladder lets the designer match the material strength to the load, so that light members are not over-specified and heavy members do not become oversized.
GB Grades: Q195 to Q420
Q195 and Q215: minimum yield 195-215 MPa, for light and secondary members
Q235: minimum yield 235 MPa, the general structural workhorse
Q355: minimum yield 355 MPa, the successor to Q345 for high-strength frames
Q420: minimum yield 420 MPa, for heavy trusses and tower legs
Q355 and Q420 are defined in GB/T 1591-2018 with impact classes B, C, D and E for service temperatures down to -40 degrees Celsius.
JIS Grades: SS400, SS540 and SM490
SS400 to JIS G3101 guarantees a minimum yield of 245 MPa and a tensile range of 400-510 MPa. SS540 raises the tensile minimum to 540 MPa with a minimum yield of 400 MPa. SM490 to JIS G3106 is the welded-structure grade with a minimum yield of 325 MPa up to 16 mm, preferred where weldability and toughness matter.
Section Sizes and Forms
Equal angles are rolled from 20 x 20 mm to 200 x 200 mm and unequal angles from 25 x 16 mm to 200 x 125 mm, with the heavy 200 x 100 mm unequal section used in large trusses and transmission towers. Sections follow GB/T 706-2016, EN 10056-1 or ASTM A6/A6M tolerances depending on the standard, and standard lengths are 6 m and 12 m.
Selection Guidance
Match the grade to the design code and the member stress. General framing uses Q235 or SS400; long-span trusses and towers use Q355, Q420 or SS540; welded structures in cold climates specify the impact-tested class of the grade. Verify the yield strength against the design value before substituting between GB and JIS grades.
Typical Applications
Transmission and communication towers
Heavy trusses and crane structures
Building frames and bracing
Bridges and gantry supports
Machinery frames and platforms
Frequently Asked Questions
Q: Which grade should I use for a transmission tower?
Tower legs and main members typically use Q355, Q420 or SS540 for high strength with light weight, while bracing uses Q235 or SS400.
Q: What does SS540 mean?
SS540 is a JIS G3101 structural grade with a minimum tensile strength of 540 MPa and a minimum yield of 400 MPa, used for higher-strength members.
Q: Is Q420 available as an equal angle?
Yes, Q420 equal angles are rolled in the heavier sizes and used where high strength must be combined with the L-section geometry.
Q: What is a 200 x 100 mm angle?
It is an unequal angle with 200 mm and 100 mm legs, one of the largest standard sections, used for heavy truss chords and tower legs.
Q: Can different grades be ordered together?
Yes, mixed-grade orders are routine and each grade is marked and certified separately for traceability.
Q: Are mill certificates supplied?
Yes, mill test certificates record the grade, heat number, chemistry and mechanical properties of every delivered angle.



















