S235JR, S275JR and S355JR Hot-Rolled I-Beams and HEA 160 H-Beams

Feb 25, 2026

Leave a message

1. The EN 10025 Grade Family

The S235JR, S275JR and S355JR grades are defined in EN 10025-2 and are the most widely used structural steels in Europe and in export projects following European practice. The number after S is the minimum yield strength in MPa, and JR indicates a Charpy impact value of 27 J at 20 degrees Celsius. All three grades are weldable with normal procedures and are available as hot-rolled I-beams, H-beams and channels.

2. Parallel-Flange Beam Series

European hot-rolled beams are rolled with parallel flanges, which makes bolted connections simpler than with tapered I-beans. The main series are IPE for medium-wide flanges, HEA and HEB for wide flanges, and HEM for the heaviest column sections. The parallel flange geometry gives straight webs and even flange surfaces that suit steel-to-steel connections and fire-protection cladding.

3. HEA 160 Dimensions and Data

An HEA 160 H-beam has a nominal depth of 152 mm, a flange width of 160 mm, a web thickness of 6 mm and a flange thickness of 9 mm, with a mass of about 30.4 kg per metre. Its section modulus is large relative to its weight, which makes it efficient for columns and beams in light-to-medium frames. Exact values come from the EN 10365 dimension tables and should be taken from the mill certificate for the delivered lot.

4. Mechanical Properties by Grade

S235JR guarantees 235 MPa yield, S275JR guarantees 275 MPa and S355JR guarantees 355 MPa, with tensile strengths of 360-510 MPa, 410-560 MPa and 470-630 MPa respectively. Elongation is above 20 percent for all grades, so cold bending and forming are possible within limits. For higher toughness or thicker sections, the J0 and J2 variants provide better impact performance.

5. Applications

These beams are used in steel building frames, mezzanine floors, bridges, agricultural sheds, platforms and industrial plants. The HEA 160 is a common choice for columns and lintels, while IPE sections suit roof and floor beams. Supplied with mill certificates, the material can be traced to the heat number for quality assurance on site.