1. Grade Overview
3Cr2W8V is a tungsten bearing hot work die steel defined in GB/T 1299, used for tools that operate at high surface temperatures. The designation indicates a nominal carbon content of 0.3 percent, chromium of about 2 percent and tungsten of about 8 percent, with a small addition of vanadium. The high tungsten content gives the steel exceptional hot hardness, so the die keeps its hardness and cutting ability even when the working surface is heated to 550°C or more.
2. Chemical Composition
The composition of 3Cr2W8V is specified as carbon 0.30 to 0.40 percent, silicon 0.40 percent maximum, manganese 0.40 percent maximum, chromium 2.20 to 2.70 percent, tungsten 7.50 to 9.00 percent and vanadium 0.20 to 0.50 percent, with phosphorus and sulphur each limited to 0.030 percent. Tungsten forms stable carbides that resist softening at high temperature, and chromium provides hardenability and oxidation resistance, while vanadium refines the grain structure.
| Element | Typical Range in Percent |
| Carbon | 0.30 - 0.40 |
| Silicon | 0.40 max |
| Manganese | 0.40 max |
| Chromium | 2.20 - 2.70 |
| Tungsten | 7.50 - 9.00 |
| Vanadium | 0.20 - 0.50 |
3. Heat Treatment Practice
Tooling made from 3Cr2W8V is hardened by preheating to 800 to 850°C, then austenitizing at 1050 to 1100°C and quenching in oil or air. The die is then double tempered at 560 to 620°C to develop secondary hardening and to relieve the stresses from quenching. The final hardness is normally in the range of 45 to 52 HRC, and the working surface can be nitrided to give an additional hard case for severe wear service.
4. Service Properties and Supply Condition
The key property of 3Cr2W8V is its resistance to softening and heat checking at high working temperatures. The steel is supplied in the annealed condition with a hardness of about 207 to 255 HB so that the die can be machined before hardening. Thermal fatigue resistance is improved by careful design of fillet radii and by a fine surface finish, and the die should be preheated before the first production run to avoid thermal shock.
5. Typical Applications
Hot forging dies for steel and non ferrous parts.
Die casting dies for aluminium and zinc alloys.
Extrusion dies and mandrels for hot metal forming.
Hot shear blades, punches and trimming tools.
Hot upsetting and hot heading tooling.
Frequently Asked Questions
Q: What does the designation 3Cr2W8V mean? It indicates a steel with about 0.3 percent carbon, 2 percent chromium, 8 percent tungsten and a small vanadium addition, following the Chinese GB/T 1299 tool steel designation system.
Q: What hardness should the die be after heat treatment? The working hardness after double tempering is normally 45 to 52 HRC, and it can be increased on the surface by nitriding for abrasive service.
Q: Why is tungsten added to this die steel? Tungsten forms stable carbides that keep the steel hard at high working temperatures, which is essential for dies that are heated by contact with hot metal.
Q: Can 3Cr2W8V be welded for die repair? Small repairs can be made with matching hot work tool steel electrodes after preheating, followed by stress relief, but large rebuilds are not recommended because of the cracking risk.
Q: What is the difference between 3Cr2W8V and H13? 3Cr2W8V has about 8 percent tungsten and higher hot hardness, while H13 has about 5 percent chromium and better toughness and thermal fatigue resistance for most die casting work.



















